Carbon Monoxide Exposures Inside an Automobile Traveling on an Urban Arterial Highway

Carbon monoxide (CO) exposures were measured inside a motor vehicle during 88 standardized drives on a major urban arterial highway, El Camino Real (traffic volume of 30,500-45,000 vehicles per day), over a 13-1/2 month period. On each trip (lasting between 31 and 61 minutes), the test vehicle drove the same 5.9-mile segment of roadway in both directions, for a total of 11.8 miles, passing through 20 intersections with traffic lights (10 in each direction) in three California cities (Menlo Park, Palo Alto, and Los Altos). Earlier tests showed that the test vehicle was free of CO intrusion. For the 88 trips, the mean CO concentration was 9.8 ppm, with a standard deviation of 5.8 ppm. Of nine covariates that were examined to explain the variability in the mean CO exposures observed on the 88 trips (ambient CO at two fixed stations, atmospheric stability, seasonal trend function, time of day, average surrounding vehicle count, trip duration, proportion of time stopped at lights, and instrument type), a fairly strong seasonal trend was found. A model consisting of only a single measure of traffic volume and a seasonal trend component had substantial predictive power (R² = 0.68); by contrast, the ambient CO levels, although partially correlated with average exposures, contributed comparatively little predictive power to the model. The CO exposures experienced while drivers waited at the red lights at an intersection ranged from 6.8 to 14.9 ppm and differed considerably from intersection to intersection. A model also was developed to relate the short-term variability of exposures to averaging time for trip times ranging from 1 to 20 minutes using a variogram approach to deal with the serial autocorrelation. This study shows: (1) the mass balance equation can relate exterior CO concentrations as a function of time to interior CO concentrations; (2) CO exposures on urban arterial highways vary seasonally; (3) momentary CO exposures experienced behind red lights vary with the intersection; and (4) an averaging time model can simulate exposures during short trips (20 minutes or less) on urban arterial highways.     

Aerosol speciation and mass prediction from toluene oxidation under high NOx conditions

A kinetically based gas-particle partitioning box model is used to highlight the importance of parameter representation in the prediction of secondary organic aerosol (SOA) formation following the photo-oxidation of toluene. The model is initialized using experimental data from York University's indoor smog chamber and provides a prediction of the total aerosol yield and speciation. A series of model sensitivity experiments were performed to study the aerosol speciation and mass prediction under high NO_x conditions (VOC/NO_x = 0.2). Sensitivity experiments indicate vapour pressure estimation to be a large area of weakness in predicting aerosol mass, creating an average total error range of 70 μg m^?3 (range of 5–145 μg m^?3), using two different estimation methods. Aerosol speciation proved relatively insensitive to changes in vapour pressure. One species, 3-methyl-6-nitro-catechol, dominated the aerosol phase regardless of the vapour pressure parameterization used and comprised 73–88% of the aerosol by mass. The dominance is associated with the large concentration of 3-methyl-6-nitro-catechol in the gas-phase. The high NO_x initial conditions of this study suggests that the predominance of 3-methyl-6-nitro-catechol likely results from the cresol-forming branch in the Master Chemical Mechanism taking a significant role in secondary organic aerosol formation under high NO_x conditions. Further research into the yields and speciation leading to this reaction product is recommended.     

Adjusted blank correction method for UV–vis spectroscopic analysis of PTIO-coated filters used in nitrogen oxide passive samplers

Passive sampling devices are popular in applications which do not require the monitoring of hourly concentrations. Nitrogen oxides are often collected using filters coated with 2-phenyl-4,4,5,5-tetramethylimidazoline-1-oxyl-3-oxide (PTIO). The filter extract can then be analyzed using flow injection analysis ion chromatography fitted with a copper/cadmium reduction column or UV–vis spectroscopy. When the latter is used to measure low concentrations of nitrogen oxides, absorbance by PTIO at the analytical wavelength of 545 nm contributes significantly. PTIO concentration on the filter also shows variation with filter storage and exposure time not accounted for in a single point blank subtraction at the analytical wavelength. A method is presented that uses a scaling factor to account for variations in concentration of PTIO on the field blank and provides a more accurate method for determining and correcting for the PTIO contribution to absorption when measuring ambient nitrogen oxide concentrations.     

Particulate,Carbon Monoxide,and Acid Emission Factors for Residential Wood Burning Stoves

Emissions from residential wood burning stoves are of Increasing concern in many areas. This concern is due to the magnitude of the emissions and the toxic and chemical characteristics of the pollutants. Recent testing of standard and new technology woodstoves has provided data for developing a family of particulate and carbon monoxide emission factor curves. This testing has also provided data illustrating the acidity of woodstove emissions. The particulate and carbon monoxide curves relate the actual stove emissions to the stove size and operating parameters of burn rate, fuel loading, and fuel moisture. Curves relating stove types to the acidity of emissions have also been constructed.

Test data show actual emissions vary from 3 to 50 grams per kilogram for particles and from 50 to 300 grams per kilogram for carbon monoxide. Since woodstove emissions are the largest single category of particulate emissions in many areas, it Is essential that these emissions be quantified specifically for geographic regions, allowing meaningful impact analysis modeling to be accomplished. Emission factors for particles and carbon monoxide are presented from several stove sizes and burn rates.

The acidic nature of woodstove emissions has been clearly demonstrated. Tests indicate woodstove flue gas condensate solutions to be predominantly in the 2.8 to 4.2 pH range. Condensate solutions from conventional woodstoves exhibited the characteristic buffering capacity of carboxylic acids when titrations were performed with a strong base. The environmental impact of buffered acidic woodstove emissions is not currently well understood; however, it is possible with the data presented here to make semi-quantitative estimates of acid emissions from particulate and carbon monoxide emission factors and wood use inventories.     

NOx Removal with Combined Selective Catalytic Reduction and Selective Noncatalytic Reduction: Pilot-Scale Test Results

Pilot-scale tests were conducted to develop a combined nitrogen oxide (NO_x) reduction technology using both selective catalytic reduction (SCR) and selective noncatalytic reduction (SNCR). A commercially available vanadium- and titanium-based composite honeycomb catalyst and enhanced urea (NH₂CONH₂) were used with a natural-gas-fired furnace at a NO_x concentration of 110 ppm. Changes in SNCR chemical injection temperature and stoichiometry led to varying levels of post-furnace ammonia (NH₃), which acts as the reductant feed to the downstream SCR catalyst. The urea-based chemical could routinely achieve SNCR plus SCR total NO_x reductions of 85 percent with less than 3 ppm NH₃ slip at reductant/NO_x stoichiometries ranging from about 1.5 to 2.5 and SCR space velocities of 18,000 to 32,000 h^?1. This pilot-scale research has shown that SNCR and SCR can be integrated to achieve high NO_x removal. SNCR provides high temperature reduction of NO_x followed by further removal of NO_x and minimization of NH₃ slip by a significantly downsized (high-space velocity) SCR.     

Partitioning of perfluorooctanoate (PFOA), perfluorooctane sulfonate (PFOS) and perfluorooctane sulfonamide (PFOSA) between water and sediment

Laboratory partitioning experiments were conducted to elucidate the sorption behaviour and partitioning of perfluoroalkyl compounds (PFCs). Three different sediment types were used and separately spiked with perfluorooctanoate (PFOA), perfluorooctane sulfonate (PFOS) and perfluorooctane sulfonamide (PFOSA) at low environmentally realistic concentrations. PFOA, PFOS and PFOSA were mainly distributed in the dissolved phase at low suspended solid concentrations, indicating their long-range transport potential in the marine environment. In all cases, the equilibrium isotherms were linear and the organic carbon normalised partition coefficients (K_OC) decreased in the following order: PFOSA (log K_OC = 4.1 ± 0.35 cm³ g⁻¹) > PFOS (3.7 ± 0.56 cm³ g⁻¹) > PFOA (2.4 ± 0.12 cm³ g⁻¹). The level of organic content had a significant influence on the partitioning. For the sediment with negligible organic content the density of the sediment became the most important factor influencing the partitioning. Ultimately, data on the partitioning of PFCs between aqueous media and suspended solids are essential for modelling their transport and environmental fate.     

Aggregation and ecotoxicity of CeO₂ nanoparticles in synthetic and natural waters with variable pH, organic matter concentration and ionic strength

The influence of pH (6.0-9.0), natural organic matter (NOM) (0-10 mg C/L) and ionic strength (IS) (1.7-40 mM) on 14 nm CeO₂ NP aggregation and ecotoxicity towards the alga Pseudokirchneriella subcapitata was assessed following a central composite design. Mean NP aggregate sizes ranged between 200 and 10000 nm. Increasing pH and IS enhanced aggregation, while increasing NOM decreased mean aggregate sizes. The 48 h-E_rC20s ranged between 4.7 and 395.8 mg CeO₂/L. An equation for predicting the 48 h-E_rC20 (48 h-E_rC20 = −1626.4 × (pH) + 109.45 × (pH)² + 116.49 × ([NOM]) − 14.317 × (pH) × ([NOM]) + 6007.2) was developed. In a validation study with natural waters the predicted 48 h-E_rC20 was a factor 1.08-2.57 lower compared to the experimental values.     

Utilization of coal fly ash in China: a mini-review on challenges and future directions

Environmental Science and Pollution Research - The rapid economic development in China places a large demand for energy, and as a result, thermal power plants in China are producing an enormous...     

A comprehensive review of climate adaptation in the United States: more than before, but less than needed

We reviewed existing and planned adaptation activities of federal, tribal, state, and local governments and the private sector in the United States (U.S.) to understand what types of adaptation activities are underway across different sectors and scales throughout the country. Primary sources of review included material officially submitted for consideration in the upcoming 2013 U.S. National Climate Assessment and supplemental peer-reviewed and grey literature. Although substantial adaptation planning is occurring in various sectors, levels of government, and the private sector, few measures have been implemented and even fewer have been evaluated. Most adaptation actions to date appear to be incremental changes, not the transformational changes that may be needed in certain cases to adapt to significant changes in climate. While there appear to be no one-size-fits-all adaptations, there are similarities in approaches across scales and sectors, including mainstreaming climate considerations into existing policies and plans, and pursuing no- and low-regrets strategies. Despite the positive momentum in recent years, barriers to implementation still impede action in all sectors and across scales. The most significant barriers include lack of funding, policy and institutional constraints, and difficulty in anticipating climate change given the current state of information on change. However, the practice of adaptation can advance through learning by doing, stakeholder engagements (including “listening sessions”), and sharing of best practices. Efforts to advance adaptation across the U.S. and globally will necessitate the reduction or elimination of barriers, the enhancement of information and best practice sharing mechanisms, and the creation of comprehensive adaptation evaluation metrics.     

Coastal flooding,climate change and environmental justice: identifying obstacles and incentives for adaptation in two metropolitan Boston Massachusetts communities

We explored the possible future impacts of increased coastal flooding due to sea level rise and the potential adaptation responses of two urban, environmental justice communities in the metropolitan Boston area of Massachusetts. East Boston is predominantly a residential area with some industrial and commercial activities, particularly along the coastal fringe. Everett, a city to the north of Boston, has a diversified industrial and commercial base. While these two communities have similar socioeconomic characteristics, they differ substantially in the extent to which residents would be impacted by increased coastal flooding. In East Boston, a large portion of residents would be flooded, while in Everett, it is the commercial/industrial districts that are primarily vulnerable. Through a series of workshops with residents in each community, we found that the target populations do not have an adaptation perspective or knowledge of any resources that could assist them in this challenge. Furthermore, they do not feel included in the planning processes within their communities. However, a common incentive for both communities was an intense commitment to their communities and an eagerness to learn more and become actively engaged in decisions regarding climate change adaptation. The lessons that can be applied to other studies include 1) images are powerful tools in communicating concepts, 2) understanding existing cultural knowledge and values in adaptation planning is essential to the planning process and 3) engaging local residents at the beginning of the process can create important educational opportunities and develop trust and consensus that is necessary for moving from concept to implementation.